In previous post, Bien Thuy help you install latest Android on latest VMWare Workstation system. It’s easy to config and install, but if there is no lucky, you will got something error or after successfully installed, your Android machine will stuck at Command like image below:
Or even something like this:
Dont worry, it is very easy to fix it. This error almost cause by a monitor or Display driver on VMware machine. Android need to run on compatible display driver and monitor, but by default, created vmware did not meet that requirement so, it will stuck at Logo boot, or even you can not start Install progress. Please refer to step below to fix it and allow our Android virtual machine start normally:
How to fix Android X86 6.0 boot stuck on Boot Logo in VMWare
Now, poweroff your machine by command: poweroff and press Enter or just close your currrent Virtual Machine Tab.
Now, look at Machine Devices, and Click into Edit Virtual Machine Settings. A new windows will open. First, we need to increase RAM of this Machine to 1GB or 2GB depend on your Computer RAM. We recommend you set this virtual RAM at half of your Computer RAM if you have less than 4GB RAM and set up to 3GB if you have more than 4GB RAM on your computer.
Next click on to Display and tick on Accelerate 3D Graphics. On Monitors tab, tick on Specify Monitor setting. Maximum resolution of any one monitor please setup to 1280×1024.
Graphics Memory please setup to 1GB. Then press OK to save your settings.
Now back and press Power on this virtual machine. It will boot to your new Virtual Android machine successful.